ENVO Snowline
ENVO Flex Snowbike - Installation Instructions
Congratulations on your new ENVO Flex Snowbike! This guide will walk you through the assembly process step-by-step. Before you begin, ensure you have all the necessary tools: Tools: Allen key Set 17mm Wrenches or Adjustable Wrench Step 1: Unboxing ...ENVO Flex Snowbike User Manual
.ENVO Snowkart Warnings
.ENVO Snowbike Kit Warnings
.Will my bike frame fit Snowbike Kit?
The Snowbike Kit is designed for a variety of bike frame designs and while most frames will be compatible with ENVO Snowbike Kit, this article explains how to make sure your bike frame is compatible. Please note the Snowbike Kit is not compatible ...ENVO SnowKart 2021 Manual
Please download the attached manual from link below.ENVO SnowKart 2020 Manual
Please download the attached manual from link below.ENVO SnowBike Conversion Kit Manual
Please download the attached manual from link below.Is it possible to use a non electric snowbike kit with a mid-drive ebike?
It's going to be difficult to match a 125mm wide track with an existing mid-drive due to little chain off-set. For regular bicycle conversion ENVO have the option to replace the crank axle with a longer one, but for mid drive motor it's generally not ...Battery does not lock properly
Incomplete installation of the battery, damage from forcing the battery to lock, battery bracket is misaligned Insert the battery completely and then apply lock. Do not apply force on the key, doing so may cause damage Check the bracket for dirt and ...Battery sparks when attached to the bracket
This is normal first turn off the switch and then insert the battery to the bracket. Doing so will prevent sparksBattery sparks when charger is inserted
This is normal when the battery is fully drained and you connect the charger, a small spark is normal, turn off the battery and then insert the charger to the wall plugThe battery is not charging
Damaged charger / pins, battery cells imbalanced Check the battery voltage with a multimeter or on the display. Fully charged battery voltage should be around 54VThe headlights are not turning on
Cables are not connected, cables are damaged Check to ensure the cables are properly attached Check for cable damage Contact us for a replacement headlight and connectorLeft motor stops when right brake is applied / right motor stop when left brake is applied
Cables are mismatched Check the label on the controller and display, Ensure (L=L) and (R=R) Swap the brake cable connectorsOne motor is spinning slowly
Motor damage, controller damage, belt tension or misalignment, ice accumulation Check the tension of the belt, both belts should have identical flexibility Check the belt tensioner at the rear of the tracks Check if ice has accumulated in the tracksBoth motors are not working
Low battery, PAS level is 0, throttle component not functioning Check the battery status Check the PAS level, it should be (1-5)Motor making a grinding noise
Motor gears may be damaged, the belt may be under stress, or the frame bearings are damaged Lift the kart, both the tracks should not touch the ground. Slowly activate the throttle and check for the noise. Compare both the tracks Locate the noise by ...The left or right motor is not working
Cable disconnected, cable damaged, the motor is damaged Check if the brakes are functioning properly, ensure the lever is completely closed Check the motor cables for damage Check the motors by swapping the controller, if the motor can be operated ...Error 30H
Occurs when green pin connection comes loose or disconnected or pins become bent Check connection and pins should be straight, reconnect
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 