Battery sparks when attached to the bracket

Battery sparks when attached to the bracket

This is normal first turn off the switch and then insert the battery to the bracket. Doing so will prevent sparks

    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • Battery sparks when charger is inserted

        This is normal when the battery is fully drained and you connect the charger, a small spark is normal, turn off the battery and then insert the charger to the wall plug

      • Battery does not lock properly

        Incomplete installation of the battery, damage from forcing the battery to lock, battery bracket is misaligned Insert the battery completely and then apply lock. Do not apply force on the key, doing so may cause damage Check the bracket for dirt and ...

      • ENVO Flex (2024) Dual Battery Setup

        Install the bracket: Remove the rubber caps from the holes on the rear side of the bike. Attach the bracket to the holes. Open the bike: Open the folding hinge and then the frame of the bike. Remove the controller plate: Remove the two Phillips ...

      • ENVO Flex Overland/SnowBike Dual Battery Setup

        Do you have the battery rail? 1: Attach the battery rail to the frame using the slots cutouts and adjust the height. 2: Attach the battery bracket (plastic part) to the battery rail using 3 screws. In case you dont have the battery rail, use the ...

      • D50/ST50 Dual Battery Setup Instructions

        1: Fasten the Dual Battery Bracket to the downtube of the bike. 2: Remove the battery from the downtube and remove the wire shield shown bellow. 3: Using three fasteners, remove the charging pins. 4: Remove the plastic side plate. 5: Push the ...