Error 30H
Occurs when green pin connection comes loose or disconnected or pins become bent
Check connection and pins should be straight, reconnect
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
0x30 Communication Error
-Communication main cable disconnection issue. The pin of the cable might be twisted or damaged. Please open the connection and check the pins of the cable. There are other sensor issues like speed, but we only see 30H error on the display. We never ...Error Code 24 - Bike Stopped Working
Please disconnect your motor cable connection which is going to your controller and reconnect it and see if the error will go away.ENVO E50 and E35 Error Codes
Error code 01E Signal communication fault 02E Throttle fault 03E Battery fault 04E Motor fault 05E Controller fault 06E Motor's Hall fault 07E Brake lever fault 10E Battery protection 11E Battery short-voltage 20E Power button fault 21E Gear button ...ENVO Stax/ Stax Pro Error 25 Troubleshooting
Disconnect the brake sensor to see if the error code disappears. If the screen returns to normal after disconnecting the sensor, then the problem is with the sensor. Loosen the clamp bolts on the shift lever and brake lever using a 5mm Allen key. ...Display Error Code (CAN-BUS)
Err code Definition 10 Over voltage protection 11 Low voltage protection 21 Controller MOSFET damaged or controller over current 12 Motor stalling 24 Motor hall fault 23 Motor phase wire fault 22 Throttle voltage is too high 13 Controller/motor over ...