ENVO Conversion Kit
The display fails to maintain accurate time.
We understand that you may have been excited to use the time display feature on your D35/ST Display, and we're sorry to inform you that it is currently not available. The display does not offer this feature and while you can set a time every time you ...
ENVO Conversion Kits Quickguide
.
ENVO Conversion Kit - Max Speed and Display Parameter Setting
ENVO Conversion Kit - Error 03 Troubleshooting
ENVO Conversion Kit: Step-By-Step Installation & Unboxing
0:30 Types of Batteries 0:59 What's inside controller kit? 1:47 How to unlock battery? 2:21 Installing Front Hub Motor 6:08 Installing torque arm on Front Wheel 9:26 Installing 36V17A Controller Bracket 10:58 Installing Rear Hub Motor 16:05 ...
Error info 6 - motor /controller cable short circuit.
When wires are looped in the same place or zip tie is tighten too much, then in overload condition the wires may get heated and might get damage. This can be observer from controller side. Please check the cable and let us know.
Error info 5 - speed sensor abnormality
- check for motor cables which might got damage.
Error info 4 - torque sensor abnormality
-Check PAS sensor on the crankshaft, as you rotate the pedals the LED should blink. -see the alignment of the disk to the sensor, the gap between sensor and disk should be 1-2mm and should maintain that distance. - look for the wire damage and dirt ...
Error info 2 - motor hall sensor abnormality
- Check for motor cables from wheel axel which might be damaged. Check for any kind of stretch wires or damaged cables from motor to controller.
Error info 1 - throttle abnormality
-Make sure the throttle level is in ideal state and don’t apply throttle while booting up system. - Check the cables, wire can be stretched or damaged or the three-pin throttle connector could have been damaged. -Check the 9-pin connector on the ...
Thru Axel vs Quick Release. What electric bike conversion kit works for each.
For a comparison please have a look at our blog post: https://ebikebc.com/thru-axel-vs-quick-release/
ENVO Conversion Kits Manual
Conversion Kit Installation Step-By-Step guide: You can download the conversion kit manual using the link below.
Is it safe to install motor on alloy or steel front forks?
Whether it’s made of alloy or steel, bike forks are designed for severe working conditions. They’re prepared for road shocks and hard braking. The amount of stress from motor axle torque is negligible compared to other loading scenarios. However, ...
Is it dangerous to have the motor on the front fork?
That depends on whether you have done your due diligence. Here are the reasons why hub motor fail, and why forks, regardless from steel or alloy, break: 1- Forcing the axle into the drop out and causing pre stress. 2- Inappropriate order or ...
Does your hub motor fit thru-axle forks?
The hub motors only work with drop out frame but for thru-axle configuration you can go with a mid drive motor.
I have a rack mounted already. Would the R35 or R50 work?
Rack battery in R series can be mounted to your existing rack, however you need to drill some holes or make some support for that.
Would the rear hub motor compliment with the R35 kit?
Yes. All batteries can technically be substituted for all motors as long as they are all the same voltage. The capacity needs to meet the motor power demand.
How do I check which battery fits on my bike’s frame?
First of all check the mounting place alternatives on your bike. The lower center of gravity is a big advantage. To check if a certain battery fits in the frame check the battery dimensions on the manual.
Are the hub motor kits compatible with disc brakes?
Yes. All hub motor kits have disk brake standard 6 bolt pattern mounting flange.