Error info 2 - motor hall sensor abnormality
- Check for motor cables from wheel axel which might be damaged. Check for any kind of stretch wires or damaged cables from motor to controller.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
Error info 4 - torque sensor abnormality
-Check PAS sensor on the crankshaft, as you rotate the pedals the LED should blink. -see the alignment of the disk to the sensor, the gap between sensor and disk should be 1-2mm and should maintain that distance. - look for the wire damage and dirt ...Error info 5 - speed sensor abnormality
- check for motor cables which might got damage.Error info 1 - throttle abnormality
-Make sure the throttle level is in ideal state and don’t apply throttle while booting up system. - Check the cables, wire can be stretched or damaged or the three-pin throttle connector could have been damaged. -Check the 9-pin connector on the ...0x30 Communication Error
-Communication main cable disconnection issue. The pin of the cable might be twisted or damaged. Please open the connection and check the pins of the cable. There are other sensor issues like speed, but we only see 30H error on the display. We never ...Display Error Code (CAN-BUS)
Err code Definition 10 Over voltage protection 11 Low voltage protection 21 Controller MOSFET damaged or controller over current 12 Motor stalling 24 Motor hall fault 23 Motor phase wire fault 22 Throttle voltage is too high 13 Controller/motor over ...