ENVO Lynx
Motor runs when rear wheel is off ground but stops with rider weight
Points to loose/bad connection or motor/controller issue. Check all electrical connections (battery, controller, motor leads). If unresolved, contact support; may indicate controller/motor upgrade needed.Throttle sometimes doesn’t activate or only works sporadically
Check throttle cable for tightness at connection. Inspect display for error codes. If throttle works but pedal assist doesn’t, PAS sensor issue likely. Reset system; escalate if still unresolved.Pedal assist takes time to engage or disengages unexpectedly
Inspect PAS sensor ring near crank for displacement/obstruction. Check for debris at sensor area. If persists, reset system and contact support if pedal assist remains inconsistent.Fender is too near tire, often after assembly or rough transit
Attempt to adjust height/angle via mounting bolts. If support wires are fixed, try gently bending them for clearance. If unresolved, contact ENVO for fender kit advice.Increased noise from motor, especially uphill/under heavy load
Check motor mount bolts for tightness. Inspect for any loose or rubbing parts. Confirm vibration isn’t from the chain or rear wheel. Contact ENVO support if noise/vibration persists, as motor may require inspection.How to install the seatpost locking clamp
ENVO Lynx 20'' Folding Lock Replacement Tutorial
Here is a tutorial on how to replace the folding lock on an ENVO Lynx 20 bike,ENVO Lynx display shows 3 charging bars even after fully charging the eBike
The most accurate way to read battery charge level is to check the voltage on the display. You can short press the power button to cycle through different data. Fully charged battery would show voltage close to 42V (it goes down for older batteries). ...ENVO Lynx Adjust Loose Seat Post and Headset
ENVO Lynx 20 Adjust Max Speed and Display Parameter Setting
Lynx 20 - Rear Derailleur Adjustment
ENVO Lynx 20" Controller Replacement
ENVO Lynx 16 Manual
.ENVO Lynx 20'' Quickguide
.Lynx 20 Display showing error 03
Motor cable connector might be stretched Check arrows alignment then push the connector back in firmly Motor cable is scratched or torn Contact ENVO support Water penetrated inside the motor casing Dry motor by putting it in a hot and dry place for ...I see Error info 01 and my throttle is not working
Check throttle positioning. Clean throttle area. It may be stuck on something, make sure you leave some space around the throttleENVO Lynx 20 Manual.
The manual for the ENVO Lynx 20 can be found attached to this article. Unboxing and Assembly Instructions (2020-2022) Please note ENVO Lynx 2023 comes fully assembled in the box.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 