Lynx 20 Display showing error 03

Lynx 20 Display showing error 03

Motor cable connector might be stretched
Check arrows alignment then push the connector back in firmly

Motor cable is scratched or torn
Contact ENVO support

Water penetrated inside the motor casing
Dry motor by putting it in a hot and dry place for 48 hours

No visible sign of damage is observed
Contact ENVO support

​



    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:


                      
           
                   Or
                                Connect with our agents through live chats  


      • Related Articles

      • ENVO Lynx 20 Manual.

        The manual for the ENVO Lynx 20 can be found attached to this article. Unboxing and Assembly Instructions (2020-2022) Please note ENVO Lynx 2023 comes fully assembled in the box.

      • Veemo display showing incorrect speed/speed limit does not work

        If you Veemo display is showing incorrect speed or the speed is above the speed limit set on the display, then your display needs to be updated with the latest Firmware update. To get the latest update, contact us at ...

      • Display shows error 06 (startup issue)

        Reboot display and controller (power off/on), check all wiring between battery and controller. Confirm battery fully charged. Contact ENVO with error code if persists.

      • ENVO Lynx 20 Adjust Max Speed and Display Parameter Setting

      • Display Error Code (CAN-BUS)

        Err code Definition 10 Over voltage protection 11 Low voltage protection 21 Controller MOSFET damaged or controller over current 12 Motor stalling 24 Motor hall fault 23 Motor phase wire fault 22 Throttle voltage is too high 13 Controller/motor over ...