Can I convert my front brakes to disc, mechanical or hydraulic?

Can I convert my front brakes to disc, mechanical or hydraulic?

Typically, yes. The hub should be Disk compatible but you will need to check to see if the front fork can support the disk brake calipers.


    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • Are the hub motor kits compatible with disc brakes?

        Yes. All hub motor kits have disk brake standard 6 bolt pattern mounting flange.

      • The brakes are making noise

        Brake pads are rubbing on the rotor Pads need to be adjusted. Adjust the cable tension to shift the left pad, use an Allen key to adjust the right pad. The pads should be adjusted so the rotor spins freely in the middle of the two pads Brakes not ...

      • ENVO Flex Overland Front brake hose rubbing with front rack.

        If you notice the front brake hose rubbing with the front carrier, make sure to change the hose routine as shown below (from the back of the fork). Step 1: Use 3mm Hex Key to remove the holder. Step 2: Use 5mm Hex Key to remove the caliper bolts. ...

      • Front fender is making noise

        Front fender is too close to the tire and is rubbing Fender needs to be adjusted, try lifting it up and moving it away from the tire, may need some slight bending, make sure you have secured it in its highest position

      • Why should you go for a front hub motor?

        95% of our customers choose front hub motor because it’s easy to install and maintain. Front hub motors perform better on slippery roads and even on snow.  Compared to a rear hub motor, you’ll save the headache of visiting a bike mechanic to place in ...