Wire harness pinched or cut, especially at folding or tight bends
Open frame sections, visually inspect wiring, repair minor insulation issues; replace harness if conductors are damaged.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
No power to display/controller after pressing power button
Try full battery charge and reseating connection. Inspect for loose/disconnected wires along harness, especially at hinges/folds. If pinched, relocate wire and tape if undamaged; replace if insulation is cut. Swap battery/controller if possible to ...Throttle loses response, or trike speed surges/drops unexpectedly
Check throttle wiring at handlebar and controller for firm connection. Inspect for cut/kinked wire at folding points. If physical harness OK, try controller reset. Test on PAS mode—if both affected, escalate for controller assessment.ENVO Lynx 20'' Folding Lock Replacement Tutorial
Here is a tutorial on how to replace the folding lock on an ENVO Lynx 20 bike,The folding hinge is loose, a small gap between folding adapter.
A simple adjustment issue. Please refer to the demonstration below. If there is a gap in folding adaptor, you can rotate the bolt counterclockwise by 2 to 3 turns, and the gap will disappear.Bike turns power on/off randomly; may be harness/switch/controller problem
Inspect for wire pinches, loose connections. Reset system and confirm all power leads. Escalate if unresolved.