Unable to fully tighten, causing alignment issues

Unable to fully tighten, causing alignment issues

Check bracket fit/alignment, remove debris, tighten bolts gradually, replace if needed.

    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • Water reaches wiring/components, causing issues

        Disconnect, dry, re-grease connectors. Escalate if repeated with photos/warranty.

      • ENVO Flex Trike Frame Alignment Tutorial

        Here is a tutorial on how to fix the tilt angle displacement on the ENVO Flex Trike Tools Required: Bubble leveler Number 6 Allen key Number 15 wrench Number 19 wrench Steps: Place the bubble leveler on the rear part of the tricycle. You will see ...

      • How to Adjust and Tighten Your Battery Bracket

        Here's a step-by-step guide to help you tighten the battery bracket: To Do: Locate the Controller: Find the controller situated at the bottom section of the battery bracket. [00:00] Remove the First Set of Screws: Identify the four screws on the ...

      • Flex Trike - How to tighten screws on cogs

        Cog on Motor is loose? You can access the screws without disassembling anything. Use an Allen Key to tighten the screws. Cog on Differential is loose? 1: Remove the Bolts keeping wheels on driving shaft. 2: Remove the rear brake caliper. 3: Unfasten ...

      • ENVO Flex Snowbike User Manual

        .