Tube fails shortly after starting use

Tube fails shortly after starting use

Inspect for production flaw vs. puncture. Replace tube; request warranty replacement if obviously defective (not regular puncture).

    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:


                      
           
                   Or
                                Connect with our agents through live chats  


      • Related Articles

      • Tire goes flat shortly after assembly

        Inspect tube for puncture before riding. Use tire levers to check for sharp rim tape or embedded debris. Replace tube if punctured. Normal flats not covered by warranty unless assembly defect.

      • What is Head tube angle, seat tube angle, stack, and reach of D35 and ST

        Please refer to the following table for the head tube angle, seat tube angle, stack, and reach values. A= Reach B= Stack C=Head tube angle D= Seat tube angle     A B C D D35 – 20’’ 400mm 682mm 71 72.6 D35 – 18’’ 377mm 681mm 71 72.6 D35 – 16’’ 331mm ...

      • The display fails to maintain accurate time.

        We understand that you may have been excited to use the time display feature on your D35/ST Display, and we're sorry to inform you that it is currently not available. The display does not offer this feature and while you can set a time every time you ...

      • Can I use the e-bike at freezing temperature like -30C?

        Typically yes.  ​ The battery will warm up once it’s in use, however you will need to cover the battery to keep warm if it is left in -30C. The battery performance will drop down if the cells temperature reaches below 5 degrees Celsius.

      • Is it possible to use a non electric snowbike kit with a mid-drive ebike?

        It's going to be difficult to match a 125mm wide track with an existing mid-drive due to little chain off-set. For regular bicycle conversion ENVO have the option to replace the crank axle with a longer one, but for mid drive motor it's generally not ...