Tire goes flat shortly after assembly
Inspect tube for puncture before riding. Use tire levers to check for sharp rim tape or embedded debris. Replace tube if punctured. Normal flats not covered by warranty unless assembly defect.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
ENVO D35: How to repair Flat Tire for you Electric Bike?
Fender is too near tire, often after assembly or rough transit
Attempt to adjust height/angle via mounting bolts. If support wires are fixed, try gently bending them for clearance. If unresolved, contact ENVO for fender kit advice.Unsure what size/wall tire or tube to buy
Check size on sidewall of original tire. Send photo + model to support for confirmation before buying replacement.ENVO D35 & ST Unboxing & Assembly Instructions
00:00 Introduction 00:11 Unboxing 00:45 Removing Protective Foam 01:07 Front Wheel Installation 02:50 D35 Handlebar Assembly 05:00 ST Handlebar Assembly 07:05 Installing Quick Release Axle 08:01 Front Fender and Headlight Installation 10:42 Pedal ...Important Update for Veemo Customers: Toe Alignment (Excessive Tire Wear)
Dear Veemo Community, The Veemo requires neutral toe alignment when loaded to ensure a safe ride, and prevent problems such as excessive tire wear. The toe angle on the Veemo changes during compression of the shock. This must be accounted for when ...