The screen turns off and the power cuts for my ebike?

The screen turns off and the power cuts for my ebike?

There are two main reasons for this happening. 

Low Charge
Charge the battery and try operating the ebike once again. 

LCD Display connector is loose
Reconnect and check all other connections inside the controller housing



    Submit a Ticket Here.



    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ‚Äč
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • Power cuts out while riding and screen goes off

        Battery runs out of charge Charge the battery LCD display waterproof cable connector is loose. Re-connect and check all other connectors in the line.  Loose conductivity between battery and bracket Check connector pins for sparks or being loose. ...
      • Can I charge my ebike battery by a Portable Power Station 518Wh Outdoor Mobile Lithium Battery Pack with 110V/500W AC Outlet?

        It is doable for partial charge but this setup cannot completely charge your bike. Here is an example of how to calculations based on your parameters work: Your charger normally needs about 200W input supply at 110V AC, this supply says 500W which is ...
      • ENVO EBike Controller Reprogramming Instructions

        The controller reprogramming device is a small device used to update program in ENVO Ebikes. Step 1: The device required DC power to operate, you can use a powerbank/laptop output to power the device. Step 2: Unplug the display cable and attach the ...
      • What do parameters like Power W (Watt) mean for ebikes?

        Watts is the measure of power (P) for motor. The power is important for riding faster both on flat or slope. There is a rated power definition for electric motor, which is the nominal power that the motor is designed to work to deliver efficiency and ...
      • System is on but motor has no power

        Loose connections Check connections and reconnect, make sure to align arrows Brake cut off sensor is malfunctioning Disconnected the brake cut off sensor, check if motor is powering Battery not sufficiently charged Check battery voltage. If the ...