Power cuts out while riding and screen goes off
Battery runs out of charge
Charge the battery
LCD display waterproof cable connector is loose.
Re-connect and check all other connectors in the line.
Loose conductivity between battery and bracket
Check connector pins for sparks or being loose.
Might need a manipulation or replacement
Loose conductivity between battery cable bullet connectors and controller
Check connectors for sparks or being loose.
Might need a manipulation or replacement
Controller overheated
Give It some moments,
open the controller bag's second expansion zip and cut some holes for ventilation there.
Battery fuse or other battery issues
Check battery output Voltage, remove and visually check the fuse if you can.
If no luck, Submit a ticket and include the report of the above tests
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
The screen turns off and the power cuts for my ebike?
There are two main reasons for this happening. Low Charge Charge the battery and try operating the ebike once again. LCD Display connector is loose Reconnect and check all other connections inside the controller housingWhat do parameters like Power W (Watt) mean for ebikes?
Watts is the measure of power (P) for motor. The power is important for riding faster both on flat or slope. There is a rated power definition for electric motor, which is the nominal power that the motor is designed to work to deliver efficiency and ...System is on but motor has no power
Loose connections Check connections and reconnect, make sure to align arrows Brake cut off sensor is malfunctioning Disconnected the brake cut off sensor, check if motor is powering Battery not sufficiently charged Check battery voltage. If the ...Can I charge my ebike battery by a Portable Power Station 518Wh Outdoor Mobile Lithium Battery Pack with 110V/500W AC Outlet?
It is doable for partial charge but this setup cannot completely charge your bike. Here is an example of how to calculations based on your parameters work: Your charger normally needs about 200W input supply at 110V AC, this supply says 500W which is ...ENVO Lynx display shows 3 charging bars even after fully charging the eBike
The most accurate way to read battery charge level is to check the voltage on the display. You can short press the power button to cycle through different data. Fully charged battery would show voltage close to 42V (it goes down for older batteries). ...