No power to display/controller after pressing power button
Try full battery charge and reseating connection. Inspect for loose/disconnected wires along harness, especially at hinges/folds. If pinched, relocate wire and tape if undamaged; replace if insulation is cut. Swap battery/controller if possible to isolate fault.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
ENVO Display User Manual
This Display is for the following products: ENVO D50/ST50 ENVO Stax/Stax Pro ENVO FlexBike does not power up (battery, controller issues)
Check main battery seated/locked. Hold power button firmly. Try known-good battery and check display connection. If dead, contact support.ENVO EBike Controller Reprogramming Instructions
The controller reprogramming device is a small device used to update program in ENVO Ebikes. Step 1: The device required DC power to operate, you can use a powerbank/laptop output to power the device. Step 2: Unplug the display cable and attach the ...ENVO Stax Display User Manual
.ENVO Flex Display User Manual
.