Motor spins when lifted off ground but stalls with rider on bike, indicating power delivery problem
Check connections between motor, controller, battery. Fully charge battery. If persists, possible controller or battery current issue. Escalate for testing/replacement.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
Motor runs when rear wheel is off ground but stops with rider weight
Points to loose/bad connection or motor/controller issue. Check all electrical connections (battery, controller, motor leads). If unresolved, contact support; may indicate controller/motor upgrade needed.Bike turns power on/off randomly; may be harness/switch/controller problem
Inspect for wire pinches, loose connections. Reset system and confirm all power leads. Escalate if unresolved.Controller doesn't communicate with battery/motor, causing total power loss
Reconnect power and motor leads. Test with known working controller. Escalate with ENVO for controller replacement.System is on but motor has no power
Loose connections Check connections and reconnect, make sure to align arrows Brake cut off sensor is malfunctioning Disconnected the brake cut off sensor, check if motor is powering Battery not sufficiently charged Check battery voltage. If the ...Is the ENVO D35 2020 a 350W or 500W motor ?
The Motor in fact is a 500W, As you can see in the LCD when you put pressure and load on the motor the number that shows on the right hand side of the display can go up to ~650W electrically Max. That means your system can easily take up to 500W ...