Its difficult to clean the battery connectors, the contacts are hard to get at. Also what product is best for this cleaning?

Its difficult to clean the battery connectors, the contacts are hard to get at. Also what product is best for this cleaning?

It is very important to keep battery conductors clean, specially when ebike is used in a dust or dirt. Particles between battery and battery bracket conductors may cause loose connectivity, sparking resulted in melting plastic parts.

How to clean?
1- Blowing air if you have an air compressor
2- Paint or tooth brush
3- Quick drying contact cleaner sprays


    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • ENVO Battery Safety Guidelines

        How to Safely Charge Ebike Battery Most reported battery fires are caused during the charging of the batteries. Hence, customers must be extra cautious when charging the batteries. Following, you can find some tips on the proper charging process: ...

      • Is it hard to ride the bike when the battery is empty?

        When the battery is dead you will have a regular bike only having 5 to 7 kg more cargo with you. There is no drag or friction by ENVO geared hub motor system.

      • ENVO Flex (2024) Dual Battery Setup

        Install the bracket: Remove the rubber caps from the holes on the rear side of the bike. Attach the bracket to the holes. Open the bike: Open the folding hinge and then the frame of the bike. Remove the controller plate: Remove the two Phillips ...

      • Battery does not charge up with standard charger?

        Battery is already fully charged Check battery voltage anything above 41V for 36V battery and anything above 53V for 48V battery is considered fully charged. Please refer to product manual for instructions on accessing voltage values.  Charger does ...

      • After 5 hours charge, the LCD display is still showing half battery. Is something wrong with battery or charger?

        The display charge indicator has a lagging system so that it’ll stabilize in cases of voltage fluctuations.  Switch the bike ON Ride for 10-15 sec, and the bars will show full.  At no load condition ~42V is fully charged ~32V is fully discharged for ...