I left the D35 / ST idle for more than 2 hours and now it is not powering up. What can I do?
The batteries in ENVO D35/ST are equipped with settings against discharge due to bike left idle for long time. The solution is simple, just take the battery out turn it off and then on and it should power up the bike.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Please fill up the support form at the link below:
Connect with our agents through live chats
ENVO ST Manual
ENVO ST is ENVO e-bikes engineered by ENVO Drive Systems in Canada for British Columbia’s steep hills, Alberta’s freezing temperatures, the Maritimes’ chilly wind, Ontario’s long commutes and Quebec with all the above applied. Unboxing and Assembly ...
ENVO D35/ST Quickguide
What is Head tube angle, seat tube angle, stack, and reach of D35 and ST
Please refer to the following table for the head tube angle, seat tube angle, stack, and reach values. A= Reach B= Stack C=Head tube angle D= Seat tube angle A B C D D35 – 20’’ 400mm 682mm 71 72.6 D35 – 18’’ 377mm 681mm 71 72.6 D35 – 16’’ 331mm ...
ENVO D35 / ST Display Fogging
We are surrounded by water vapors present in the atmosphere and we quantify this as "humidity". Some areas are humid (such as shoreline) while others may be dry (such as deserts). When the electronic display is produced some of the air is captured ...
I took out the battery while the D35 / ST bike was on, now when I tried to insert the battery back the bike doesn't power on.
The battery is safeguarding against the short circuit. All you need to do is turn the battery off and then on and the bike should work fine.