Error flashes on display, stalls assist

Error flashes on display, stalls assist

Note error code, consult user manual or ENVO KB for code lookup. Perform recommended fix (often resetting controller, checking sensors/connections).

    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • ENVO Display User Manual

        This Display is for the following products: ENVO D50/ST50 ENVO Stax/Stax Pro ENVO Flex

      • ENVO Flex Display User Manual

        .

      • ENVO Stax Display User Manual

        .

      • Display Error Code (CAN-BUS)

        Err code Definition 10 Over voltage protection 11 Low voltage protection 21 Controller MOSFET damaged or controller over current 12 Motor stalling 24 Motor hall fault 23 Motor phase wire fault 22 Throttle voltage is too high 13 Controller/motor over ...

      • 0x30 Communication Error

        -Communication main cable disconnection issue. The pin of the cable might be twisted or damaged. Please open the connection and check the pins of the cable. There are other sensor issues like speed, but we only see 30H error on the display. We never ...