Connection procedure for 50 Series Tail light

Connection procedure for 50 Series Tail light

Submit a Ticket Here.

---

We're happy to help:

Still can't find the solution?

Please fill up the support form at the link below:

                  

       

               Or

                            Connect with our agents through live chats  

• Related Articles

• Rear light does not illuminate after install

  Check connection and alignment, if battery LED, test/replace battery. Replace light if faulty under warranty.

• Rear light is dead or does not illuminate

  Confirm if light is battery-powered or wired. Replace or charge batteries if standalone. Check connection if wired. If still inoperable, request new light from support.

• Rear light inoperable post-build

  Confirm correct wiring/connection, replace bulb/LED as needed. If still non-functional, request warranty replacement.

• D35/ST Rear Taillight doesnt turn on when turning on the front light.

  Check the connection between the taillight and controller, if the connector is loose or the wire is damaged replace that.  On the other hand, if you notice that the rear taillight is working when pressing the brake (feature available in few newer ...

• Procedure: Replacing the DC-DC Converter on the Veemo

  This article provides a step-by-step guide to replace the old DC-DC converter in your Veemo with the new low-draw version. This replacement addresses the issue of excessive power drain during standby mode. Customers with the affected converters will ...