Brakes rub or squeak post-assembly
Loosen caliper mount, recenter over rotor, retighten. Spin wheel; adjust until noise/rub resolves.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
The brakes are making noise
Brake pads are rubbing on the rotor Pads need to be adjusted. Adjust the cable tension to shift the left pad, use an Allen key to adjust the right pad. The pads should be adjusted so the rotor spins freely in the middle of the two pads Brakes not ...Brakes squeak, even after break-in
Clean discs and pads (isopropyl), bed new pads, check pad-to-disc alignment as per ENVO resource.ENVO D35 & ST Unboxing & Assembly Instructions
00:00 Introduction 00:11 Unboxing 00:45 Removing Protective Foam 01:07 Front Wheel Installation 02:50 D35 Handlebar Assembly 05:00 ST Handlebar Assembly 07:05 Installing Quick Release Axle 08:01 Front Fender and Headlight Installation 10:42 Pedal ...Rear light does not work post-assembly or randomly fails.
Test wiring and LED. Try different power source. Escalate if failure persists after troubleshooting.Bolts for racks, brakes, or accessories strip or cross-thread during assembly
Never force bolts. Use proper size/thread. If stripped: replace part or use thread insert. Escalate persistent frame/hardware defects.