Bike does not power up (battery, controller issues)
Check main battery seated/locked. Hold power button firmly. Try known-good battery and check display connection. If dead, contact support.
Submit a Ticket Here.
We're happy to help:
Still can't find the solution?
Or
Connect with our agents through live chats 
Related Articles
I took out the battery while the D35 / ST bike was on, now when I tried to insert the battery back the bike doesn't power on.
The battery is safeguarding against the short circuit. All you need to do is turn the battery off and then on and the bike should work fine.No power to display/controller after pressing power button
Try full battery charge and reseating connection. Inspect for loose/disconnected wires along harness, especially at hinges/folds. If pinched, relocate wire and tape if undamaged; replace if insulation is cut. Swap battery/controller if possible to ...ENVO Flex (2024) Dual Battery Setup
Install the bracket: Remove the rubber caps from the holes on the rear side of the bike. Attach the bracket to the holes. Open the bike: Open the folding hinge and then the frame of the bike. Remove the controller plate: Remove the two Phillips ...Can I charge my ebike battery by a Portable Power Station 518Wh Outdoor Mobile Lithium Battery Pack with 110V/500W AC Outlet?
It is doable for partial charge but this setup cannot completely charge your bike. Here is an example of how to calculations based on your parameters work: Your charger normally needs about 200W input supply at 110V AC, this supply says 500W which is ...ENVO Battery Sleep Mode Function
ENVO Batteries are equipped with a sleep mode function that gets triggered after 8 hours of no activity. After having ridden the bike they will go into power saver mode after 7-8 hrs. You will need to reset the batteries after this period by removing ...