0x30 Communication Error

0x30 Communication Error

-Communication main cable disconnection issue. The pin of the cable might be twisted or damaged. Please open the connection and check the pins of the cable.

There are other sensor issues like speed, but we only see 30H error on the display. We never encountered hall sensor issue. 



    Submit a Ticket Here.


    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • ENVO E50 and E35 Error Codes

        Error code 01E Signal communication fault 02E Throttle fault 03E Battery fault 04E Motor fault 05E Controller fault 06E Motor's Hall fault 07E Brake lever fault 10E Battery protection 11E Battery short-voltage 20E Power button fault 21E Gear button ...

      • Display Error Code (CAN-BUS)

        Err code Definition 10 Over voltage protection 11 Low voltage protection 21 Controller MOSFET damaged or controller over current 12 Motor stalling 24 Motor hall fault 23 Motor phase wire fault 22 Throttle voltage is too high 13 Controller/motor over ...

      • ENVO Flex Display User Manual

        .

      • Unit throws error after startup

        Crosscheck error in KB, execute fix. If unclear/escalate with screenshots to support.

      • Error persists, no fix with standard reset

        Check error code meaning in ENVO KB. Address (e.g., for Error 25, replace bottom bracket). Escalate with evidence if issue persists.