0x25 Torque signal error (related to brake/throttle/PAS)

0x25 Torque signal error (related to brake/throttle/PAS)

-usually happens when brake/throttle applied and then turning on the bike.

- keep the brake/throttle/pas in ideal condition don’t apply brake or throttle and let the system completely bootup.



    Submit a Ticket Here.



    We're happy to help:

    Still can't find the solution?

    Please fill up the support form at the link below:

                      
           
                                      Or
    Connect with our agents through live chats  


      • Related Articles

      • Throttle or display malfunction after installing mirror or accessories on the handlebar

        The mirror or the accessories are rubbing throttle's moving parts causing the issue Move these parts and create a reasonable clearance with throttle. If there is no physical contact between installed items yet the throttle or controller has issues or ...
      • Does the throttle on D35/ST work on PAS 0?

        All the D35/ST prior to 2022 had a throttle that did not work on PAS 0 but then after the feedback from the customer the setting was changed, and all D35/ST produced in the second half of 2022 and onward had the setting where throttle works on PAS ...
      • Error info 1 - throttle abnormality

        -Make sure the throttle level is in ideal state and don’t apply throttle while booting up system.  - Check the cables, wire can be stretched or damaged or the three-pin throttle connector could have been damaged. -Check the 9-pin connector on the ...
      • Is torque sensor pedal assist system (PAS) better than motion sensor?

        Generally speaking torque sensor is a more sophisticated technology which is getting a good performance and feedback on electric bikes such as those integrated with Bosch, Shimano or Yamaha ebike motor systems. Torque sensor should have an integrated ...
      • Error info 4 - torque sensor abnormality

        -Check PAS sensor on the crankshaft, as you rotate the pedals the LED should blink. -see the alignment of the disk to the sensor, the gap between sensor and disk should be 1-2mm and should maintain that distance. - look for the wire damage and dirt ...